#Porthole front door serial number

Resetting is needed if you want to connect your ZigBoat™ Porthole/Door Sensor to another gateway or if you need to perform a factory reset to eliminate abnormal behavior. You can test if the positioning of the sensor and magnet are correct by checking whether the green light on the ZigBoat™ Porthole/Door Sensor is flashing when you open or close the porthole/door. The magnet may also be placed either facing the side of the sensor or sitting parallel to it. This does affect the maximum distance allowed.

The sensor and magnet may be placed on separate three dimensional planes, though.

The most important consideration is for the magnet to be placed as near to the point on the sensor indicated by the grey arrow.

There are many ways to mount the sensor and magnet, as portholes and doors vary greatly.

The magnet (b) should be mounted on the door or porthole no further than 5mm away from the arrow on the sensor.

The ZigBoat™ Porthole/Door Sensor (a) should be mounted to the frame using the double stick tape, already applied on the back of the sensor and magnet.

In case of a weak or a bad signal, change the location of the ZigBoat™ Porthole/Door Sensor.

The magnet and sensor also have to be aligned/centered thickness-wise on as similar level as possible.The magnet has to be placed on that side of the sensor which is marked with a small triangle.Place the sensor indoors at a temperature between 0-50☌.In case of a weak or a bad signal, change the location of the ZigBoat™ Porthole/Door Sensor.

#Porthole front door serial number

Please check you have insert the correct serial number.Red dot: The sensor is not able to reach the Green dot: The sensor is working properly To check the correct configuration, select the overview tab of the ZigBoat™ App. When the red LED stops flashing, the ZigBoat™ Porthole/Door Sensor has successfully joined the ZigBoat™ network.While the ZigBoat™ Porthole/Door Sensor is searching for the ZigBoat™ network to join, the red LED is flashing.

The ZigBoat™ Porthole/Door Sensor will now start searching for the ZigBoat™ network to join.

Insert the enclosed batteries (2xAAA) into the device, respecting the polarities.

You can change the devices name by selecting “Name” (fig.

To locate the serial number of the sensor, remove the front cover by pressing the tab on top. Select “Device list” (fig.2) Add the sensor by entering the serial number which is on the sensor’s label (fig.3).

Open the ZigBoat™ App, select the Gateway in the ZB Gateways menu, wait a few seconds, then select the menu button on the top right (fig.